鋁基板如何控制分板機不變形？
用
分板機效果最好。bai鋁基板的話可以看看三刀式du燈條分板機，zhiASC-720機器采用獨特的多連多切割方法，電dao路板切割由六片刀片完成，上下兩片為一組，構成一個切割單元。分別是A、B、C、三組。整個切割過程分為三個階段，A組刀片先切割電路板40%，接著B刀片再次從A刀片切過的槽中碾過，再次完成40% 的切割量，最后由C組刀片切割最后的20% 并修光，由于每次的切割量很小，因此切割過程中產生的應力較傳統(tǒng)的一次切斷方式減少了80% 以上，分割好的電路板邊緣平整光滑，板面非常平整，不扭不翹。是目前市面上唯一的走板式能保證切割后鋁基板不變形的機器。
The best result is obtained by using the board dividing machine. For Bai aluminum substrate, you can look at the three knife Du lamp strip splitter. Zhiasc-720 machine adopts a unique multi connected multi cutting method. The electro Dao circuit board cutting is completed by six blades, and the upper and lower two pieces form a group, forming a cutting unit. They were group A, group B, group C and group C. The whole cutting process is divided into three stages: group a blade first cuts 40% of the circuit board, then B blade grinds again from the groove cut by blade a, completes 40% of the cutting volume again, and finally cuts the last 20% and polishes by group C blade. Because the cutting amount is small each time, the stress generated in the cutting process is reduced by 80% compared with the traditional one-time cutting method The edge of the divided circuit board is flat and smooth, and the board surface is very flat without twisting or warping. At present, it is the only walking board machine on the market to ensure that the aluminum substrate is not deformed after cutting.
